HIGH PERFORMANCE BELT AND CHAIN LUBRICANTS

USAGE INSTRUCTIONS:

 

• Ensure that parts to be lubricated are reasonably clean and free from old oils and greases.
• Using a natural hair brush, apply a THIN layer of 00T^TM 800F Belt & Chain Lubricant> to the HOT moving part. Note that for best results, always apply a thin layer of this lubricant on the hot clean surface.
• The use of 00T^TM 800F Belt & Chain Lubricant does not require "burn off".
• The standard viscosity of 00T^TM 800F Belt & Chain Lubricant available is rated at 525 cSt. @ 40ºC and 46.5 cSt. @ 100ºC. 00T^TM 800F Belt & Chain Lubricant is also available in a thicker get formulation (for bearings, seal and gears) through special orders. Consult Kem-A-Trix^TM or distributor.

TYPICAL CHARACTERISTICS

Drop point (ASTM D-2265)	None	Odor	None
Timken OK Load (ASTM D-2059 lb., min.)	50+	Thickener	Synthetic
Corrosion protection (ASTM D-1743)	Pass	Fillers	Synthetic
Underwater adhesion ASTM D-2510	Pass	Silicone	None
Load wear index	51	Color	Clean light amber
Wheel bearing test@ 135ºC.	Pass	Shelf life (sealed, light-proof container)	10 years

 

"Economy Through Superior Quality"

Notice: All statements and specifications in this brochure are based on analytical tests and service experience. Because of the variety of applications and equipment used along with the unpredictability of equipment conditions and human factor involved in the use of this product, Kem-A-Trix^TM (Lubricants) Inc. makes no warranties expressed or implied that the product or products described are guaranteed for any length of time, any measure of service or for any specific purpose. The buyer should ascertain proper suitability, preparation and technique of use for the buyer's application or applications. Kem-A-Trix's only warranty is that its products conform to written specifications and are free from defects under normal usage. Kem-A-Trix^TM disclaims warranties of merchantability or fitness for any particular use or purpose.