USAGE INSTRUCTIONS:
- For general lubrication, apply as normal after having removed all old grease.
- For bearing application, clean or replace. Before applying Thermo-GelTM, TG600AW thoroughly clean the bearings to remove traces of conventional greases, to avoid any incompatibility problems. Even new bearings should be cleaned of any slush or oils, and the cleaning solvents allowed to completely evaporate before applying Thermo-GelTM, TG600AW. Do not overfill bearing. Pack rolling elements as with conventional greases, but fill only to about 30% full. Overfilling can cause failure due to over-heating and wear.
- Allow machinery to run to operating temperature Thermo-GelTM TG600AW will remain a clean translucent green and change to a resilient consistency at 250ºF, when it "gels" forming ensuring it will not melt, drip or run out under conditions of high temperature, high shear or high loading.
- To top up bearing lubrication, simply add. Because Thermo-GelTM TG600AW delivers extended service life (on average 10 times longer than conventional lubricants), adjust lubrication schedule to benefit from this important product feature.
- Use recommended NLGI viscosity grade. NLGI viscosity grade numbers 2 and 3 are standard; other viscosity grades are available on special order. Consult Kem-A-TrixTM or distributor.
TYPICAL CHARACTERISTICS
| Drop point ASTM D-2265 | None | Odor | None |
| Timken OK Load ASTM D-2059 lb., min. | 60+ | Thickener | Synthetic |
| Corrosion protection ASTM D-1743 | Pass | Fillers | Synthetic |
| Load wear index | 51 | Silicone | None |
| Water Resistance ASTM D-1264, Max.Wt. % @ 175¸F (79ºC) |
Pass | color | Light green |
| Usage temperature | 0ºF to 600º F-18ºC to 315ºC |
Shelf life (sealed, light-proof container) |
> 10 years |
"Economy Through Superior Quality"
Notice: All statements and specifications in this brochure are based on analytical tests and service experience. Because of the variety of applications and equipment used along with the unpredictability of equipment conditions and human factor involved in the use of this product, Kem-A-TrixTM (Lubricants) Inc. makes no warranties expressed or implied that the product or products described are guaranteed for any length of time, any measure of service or for any specific purpose. The buyer should ascertain proper suitability, preparation and technique of use for the buyer's application or applications. Kem-A-Trix's only warranty is that its products conform to written specifications and are free from defects under normal usage. Kem-A-TrixTM disclaims warranties of merchantability or fitness for any particular use or purpose.
